Filter
Top Products
Country-Specific Information C-35
Country-Specific
Information
Compliance with DTI 83/009I
This modem has been approved for use of the following facilities:
• Loop disconnect and multifrequency signaling
• Storage of telephone numbers for retrieval by a predetermined code
• Detection of initial proceed indication
• Operation of the absence of proceed indication
• Automatic dialing facilities
• Tone detection, i.e., Ring Tone, etc.
• Multiple repeat attempt facility
• Automatic clearing from call originating end
• Call progress monitor
• Series connection
• Modem
• PBX timed break register recall
• Auto answer
Any other usage will invalidate the approval of the apparatus if, as a result, it ceases
to conform to the standards against which approval was gained.
This apparatus is only approved for compatible PBXs. Telenetics should be con-
sulted for an up-to-date list of compatible PBXs.
There is no guarantee that the apparatus will work in all circumstances. Any
difficulty should be referred to Telenetics.
This apparatus is suitable for connection to a PABX which returns secondary
proceed indication.
Compliance with BS6301
Only apparatus conforming with BS6301 may be connected to the telephone socket
on the rear of the modem.
Any interconnection between the above socket and the other modem connections,
directly or by way of other apparatus, may produce hazardous conditions on the BT
network. Advice should be obtained from a competent engineer before any such
connection is made.
Compliance with BABT SITS 83/009 Section D
Caution
Do not enter more than two “4” second pauses following the
initial access digit (or digits). Failure to comply with this
requirement may result in unsatisfactory operation.