Filter
Top Products
Installing the Modem 2-15
Installing
the Modem
Automatic Self-Test
When you apply power to the modem, it automatically runs a self-test that checks for
and identifies faults in the modem’s circuits. After displaying the message SELF-
TEST, the front modem displays one of the messages shown in Table 2-1.
Handling Error Messages
If the modem fails the self-test and displays an error message, do the following:
1) Record the message to assist in troubleshooting the modem.
2) Turn the modem off and then on again, and observe the front panel display.
If the modem displays 326X READY, the earlier error message was probably
caused by a temporary power line problem. Some line problems do not affect
modem operation. If the modem continues to display an error message, contact
Telenetics Customer Support or an authorized Telenetics distributor.
After Installing the Modem...
Go on to Chapter 3, Getting Started, for information on how to configure and operate
the modem.
Table 2-1.
Self-Test Messages
This Message... Indicates:
326X Initial The modem is set to operate using factory default values.
326X Ready No faults were encountered during the self-test. The modem is ready
for operation.
[Error message] A system fault was detected during the self-test.