Filter
Top Products
FET Specific Menus
C-4
C.1.14 EMULATOR->GIE on/off
Enables or disables all interrupts. Needs to be restored manually before GO.
C.1.15 EMULATOR->LEAVE TARGET RUNNING
If C-SPY is closed, the target keeps running the user program.
C.1.16 EMULATOR->FORCE SINGLE STEPPING
On GO the program is executed by single steps. Only in this mode the cycle
counter works correctly.
C.1.17 EMULATOR->SET VCC
On the USB FET the target supply voltage can be adjusted between 1.8V and
5.0V. This voltage is available on pin 2 of the 14-pin target connector to supply
the target from the USB FET. If the target is supplied externally, the external
supply voltage should be connected to pin 4 of the target connector, so the
USB FET can set the level of the output signals accordingly.
Note: Availability of EMULATOR->ADVANCED menus
Not all EMULATOR->ADVANCED menus are supported by all MSP430
devices. These menus will be grayed-out.