Filter
Top Products
MSP-FET430UIF Installation Guide
F-4
Figure F-4. WinXP Driver Installation
8) In the next step the Wizard installs the driver files.
9) The Wizard now shows a message that it has finished the installation
of the software for “MSP430 USB FET Adapter”.
10) After closing the Hardware Wizard, Windows automatically recognizes
another new hardware device called “Texas Instruments UMP Serial
Port”.
11) Depending on the current update version of the OS corresponding
drivers are installed automatically or the Hardware Wizard pops up
again. In case of the Wizard is started, please repeat the steps already
described above again
12) Finally the MSP-FET430UIF debug interface is installed and ready to
use. The Device Manager should list a new entry as shown in Figure
F-5.