Filter
Top Products
72 4200FA Installation and Operation Manual
Toolbar: Security 9.12
The UPS initializes in the USR, or lowest security mode. To change the display security level, press the
Security button.
The screen displays an alpha/numeric keypad to enter the appropriate password for the desired security
level. The UPS ships with a default ADM password of ADMIN.
In the example below, to change the security level from USR to ADM:
1. Press the Security button. The alpha/numeric keypad is displayed.
2. Type in the ADM password “ADMIN” - Press the ABC button once for A, twice rapidly for B, etc.
3. After entering the password, press WRITE.
4. If the password is accepted the display will show “Successful”. Press QUIT to return to the Main
display, and the Security button will display the ADM security level.
If the password is not accepted, the screen will return to the Main display and the Security button
will display the USR level.
Figure 9-9 Changing Security Level
Toolbar: Buzzer ON/OFF 9.13
The UPS Buzzer sounds when a fault occurs or when the UPS is switched to backup mode. The Toolbar
allows the user to turn on/off the buzzer.
The buzzer can also be enabled or disabled through the setup menu. If the Buzzer is disabled through
the setup menu, the Toolbar Buzzer button will be disabled.
Toolbar: Touch ON/OFF 9.14
The touchscreen can be turned OFF (locked) by pressing the TOUCH ON/OFF button. With TOUCH
OFF, only the TOUCH button is active, the rest of the display will not respond to touch.
Toolbar: QUICK VIEW ON/OFF 9.15
At anytime while using the tabs to view system details, the summary of the UPS Input, Output, and DC
Bus can be viewed by pressing the Q. VIEW button (Button will display Q. VIEW ON). The illustration
below highlights the critical features of the Quick View display.
Exit Quick View by pressing the Q. VIEW button again. (Button will display Q. VIEW OFF)