Filter
Top Products
4/00, TecraToshiba TRR Page 14
Tecra 750 Series Disassembly Overview, (cont.)
To install the Selectable Bay cover, follow the
steps below.
1. To install the cover, first remove the
Selectable Bay module then hold the
cover by the two finger grips and push it
into place until you hear the latches
click.
2. To remove the cover, grasp the two
finger grips and pull the cover out.
To disassemble the FDD, follow the steps below.
1. Remove six M2x6 silver screws.
2. Turn the FDD over and release two
latches securing the upper plastic
frame and lower plastic frame. Turn it
back over and lift off the cover.
3. Lift off the upper shield cover, unseat
the flexible cable connector from the
lower plastic frame, then lift out the
FDD.
4. Pull the flexible cable out of the FDD
connector.
5. Remove four M2.5x2.8 black screws
and remove the FDD from the bracket.
ê
î