Filter
Top Products
4/00, TecraToshiba TRR Page 18
Tecra 750 Series Disassembly Overview, (cont.)
To install a memory module(s), make sure the
computer is in boot mode and follow the steps
below.
CAUTION: Do not try to install a memory
module(s) with the computer turned on. You
can damage the computer and the
module(s).
1. Position the connector on the bottom of
the module over the corresponding
connector on the computer. Place your
fingers above the connector and press
firmly but gently to ensure a solid
connection. The module should be
seated level.
CAUTION: Do not touch the connectors on
the memory module(s) or on the computer.
Debris on the connectors may cause
memory access problems.
2. Lay the cover in place and secure it
with two M2x3 silver screws.
3. Install the battery pack, and HDD.
í
The modem board is located under the palmrest.
To open the palmrest, follow the steps below.
1. Turn off the power to the computer.
Disconnect the AC adapter and all
external cables connected to the
computer.
2. Remove the battery pack, HDD pack,
and optional memory module.
3. With the computer upside down,
remove three M2x8 silver screws and
two M2x22 silver screws.
4. Turn the computer right side up and
open the display panel and the PC card
cover.
5. Grasp the sides of the palmrest and pull
it forward until tabs on either side clear
holes on the top cover.
6. Carefully lift the palmrest to avoid
damage. Three latches are located
under the palmrest as shown below.
7. Remove four M2.5x6 screws in the
modem slot and lift out the modem
pack.
8. Disconnect the modem pack flexible
connector from the system board.
î
ê