Filter
Top Products
4 Replacement Procedures
4-30 Satellite A130/ A135 Series Maintenance Manual
Reassembling the Optical Drive
NOTE: The small arrow shown on the metal bracket indicates the top side of the optical
bracket. Keep this in mind when removing or installing the drive.
To reassemble an optical drive, follow the steps below and refer to the figure in the preceding
section.
1. Position the optical drive bracket plate so that it is aligned with the rear panel of optical drive.
2. Secure the optical drive bracket plate with two
M2x3 screws.
3. Install the optical drive module into the bay as described in the preceding section.