Filter
Top Products
4 Replacement Procedures
3. Remove the system board after making sure that all connectors are removed from their
respective sockets.
Figure 4-74 Removing the system board
Installing the System Board
To install the system board, follow the steps below and refer to the figures in the preceding
section.
1. Seat the system board in the chassis. Take care to align all the ports and connectors in their
respective openings on the chassis.
2. Replace the two M2.5x6 screws and two M2.5x3 screws securing the system board.
3. Replace the two hexagonal screws to secure the VGA port.
4. Connect the power connector in its socket.
Satellite A130/ A135 Maintenance Manual 4-61