Toshiba A500 Laptop User Manual


 
User’s Manual 8-7
Satellite A500/A500D
Point to note about memory module error
If you install a memory module that is not compatible with the computer, the
Power indicator will flash in the following ways:
If there is an error in only Slot A or no memory module is inserted in Slot
A: repeatedly flashes amber twice, then green.
If there is an error in Slot B: repeatedly flashes amber, then green twice.
If there are errors in both Slot A and Slot B: repeatedly flashes amber
twice, then green twice.
In all instances you should shut down the computer and remove the
incompatible module(s).
Installing a memory module
The computer contains slots for two memory modules, one positioned
immediately over the other - the procedures are the same for installing
either module.
1. Shut down the computer - make sure the Power indicator is off (refer to
the Turning off the power section in Chapter 3, Getting Started, if
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down and remove the memory module cover.
Figure 8-4 Removing the memory module cover
Use a # 0-point Phillips screwdriver to remove and fasten the screws -
the use of an incorrect screwdriver can damage the screw heads.
1. Memory module cover
2. Screw
3. Slot B
4. Slot A
1
2
3
4