Filter
Top Products
3. REPLACING THE IMPORTANT PARTS EO18-33025
(Revision Date: Mar. 27, 2009)
3.3 Replacing the Main PC Board
3-8
6. Replace the main PC board with a new one, then reassemble in the reverse order of
removal.
7. After replacement, perform the following operations.
● Perform a media sensor calibration with the button of the printer or B-EV4 Setting
Tool.
Regarding the media sensor calibration, refer to the Owner’s Manual or the B-EV4
Setting Tool Specification posted on the Barcode Knowledge Pot.
URL of Barcode Knowledge Pot:
http://barcode.toshibatec.co.jp/Ris/products/barcode/support/en/index.php
● Perform a printer parameter setting with the B-EV4 Setting Tool.
● Perform an interface setting (RS-232C, Eternet) with the B-EV4 Setting Tool.
NOTE: It is possible to save/upload the printer parameter and interface setting
into/from the PC with the B-EV4 Setting Tool.
8. Also, make sure the printer performs correctly for the following points.
• The sensor adjustment is performed correctly.
• Printing is performed correctly during the diagnostic test print.
• When the PC connected to the printer sends sample data to the printer, printing is
performed correctly.
NOTE: Firmware download onto the Main PC board
Perform a firmware download onto the Main PC board if necessary (in the case of
alteration/addition to the specification).
Regarding the download procedure, refer to Firmware Down Loading Procedure
which is posted on the Barcode Knowledge Pot. The firmware program to be
downloaded is also available from this website.