Filter
Top Products
3. REPLACING THE IMPORTANT PARTS EO18-33025
(Revision Date: Mar. 27, 2009)
3.12 Replacing the Feed Gap Sensor (Lower)
3-24
3.12 Replacing the Feed Gap Sensor (Lower)
1. Refer to section 3.1 to remove the top cover.
2. Use the Phillips screwdriver to remove the 2 screws from the mylar sheet.
3. Remove the mylar sheet.
4. Remove the sensor connector from the main PC board.
5. Use the Phillips screwdriver to remove the screw from the sensor plate.
6. Remove the sensor plate.
7. Remove the feed gap sensor (lower).
8. Replace the feed gap sensor (lower) with a new one, then reassemble in the reverse
order of removal.
Sensor Connecto
r
(JP29)
Main PC
Board
Sensor plate
T
-1.5x4 Screw
Feed Gap Sensor (lower)
Mylar Sheet
FL
T
-3x6 Screw