Filter
Top Products
Windows Setup Guide for ST-6500/ST-6500-C7
TOSHIBA TEC CORPORATION
17
w Installing the Intel 810/815 Chipset Family Graphics
To enable the CRT display, install this driver.
Execute “Chipset¥Graphics¥Win2K_XP¥Graphics¥Setup.exe” contained in the driver kit,
and install the “Intel 810/815 Chipset Family Graphics Driver.”
Reboot the machine. Select [Touch Panel] on the Control Panel to display the “Touch
Panel Property” screen. On this screen, select [Calibration] – [Execute] to set up
calibration.
IMPORTANT:
* Unless any of the PS/2 mouse, the serial mouse or the USB mouse has been
connected, the touch panel driver cannot be loaded properly, disabling the
calibration setup. Connect any of the mice to let the machine recognize it.
4) Installing Other PCI Device Drivers
Execute “Chipset¥LAN¥100pdisk.exe” contained in the driver kit, and extract the files onto
the hard disk.
The Windows 2000 Device Manager indicates that “Ethernet Controller” and “Video
Controller” are not properly installed.
Open the properties screen for the device with the “?” mark and click on “Reinstall Driver.”
Install these controllers in the same manner as the PnP Tablet Driver.
Designate the following folders:
Ethernet Controller: Folder that 100pdisk.exe was extracted to
Video Controller: “Display¥SM712¥Win2K” in the driver kit