Filter
Top Products
Windows Setup Guide for ST-6500/ST-6500-C7
TOSHIBA TEC CORPORATION
7
8) Setting up the Dual Display
To enable the dual display, carry out this setup.
The ST-6500-C7 enables the dual display using the Dual Display functions supported by
Windows.
Select [Display] on the Control Panel to display the “Display Properties” screen. On this
screen, select [Settings] – [Display]. Select the on-board VGA (Intel810E2)-equipped
display. Check the “Extend my Windows desktop onto this monitor” checkbox at the lower
left, then click on the “Apply” button. The on-board VGA will be enabled.
Select proper “Colors” and “Screen area”.
IMPORTANT:
* Windows 98/98SE/2000/XP can use the Dual Display functions supported by the
OS. However, Windows NT cannot use the Dual Display functions, since
Windows NT does not support them.