Filter
Top Products
Windows Setup Guide for ST-6500/ST-6500-C7
TOSHIBA TEC CORPORATION
23
Reboot the machine. Select [Control Panel] – [Touch Panel] to display the “Touch Panel
Property” screen. On this screen, select [Calibration] – [Execute] to set up calibration.
IMPORTANT:
* Unless any of the PS/2 mouse, the serial mouse or the USB mouse has been
connected, the touch panel driver cannot be loaded properly, disabling the
calibration setup. Connect any of the mice to let the machine recognize it.
4) Installing Other PCI Device Drivers
Designate the following folder to install the driver:
Video Controller: “Display¥SM712¥WinXP” in the driver kit
5) Changing the Serial Port Setting
On Windows XP, COM4 is recognized as if there are two. Therefore, either of them must be
changed from COM4 to COM5 (SIO1).
IMPORTANT:
* No additional operation for the SIO1 port is required, since it cannot be actually
used due to hardware configuration. However, since COM4 is recognized as if
there are two, either of them must be changed from COM4 to COM5 (SIO1). The
port addresses and IRQs for COM4 and COM5 should be set as below:
• COM4
Port address: 270-277
IRQ: IRQ11
• COM5 (SIO1)
Port address: 2E8-2EF
IRQ: IRQ15
6) Updating the Driver
The driver kit contains divers newer than those supported by Windows. Update the drivers
as required.