Filter
Top Products
Windows Setup Guide for ST-6500/ST-6500-C7
TOSHIBA TEC CORPORATION
18
5) Changing the Serial Port Setting
On Windows 2000, COM4 is recognized as if there are two. Therefore, either of them must
be changed from COM4 to COM5 (SIO1).
IMPORTANT:
* No additional operation for the SIO1 port is required, since it cannot be actually
used due to hardware configuration. However, since COM4 is recognized as if
there are two, either of them must be changed from COM4 to COM5 (SIO1). The
port addresses and IRQs for COM4 and COM5 should be set as below:
• COM4
Port address: 270-277
IRQ: IRQ11
• COM5 (SIO1)
Port address: 2E8-2EF
IRQ: IRQ15
6) Updating the Driver
The driver kit contains drivers newer than those supported by Windows. Update the drivers,
as required.