Filter
Top Products
16
cable is fully seated into the modular connector, and route the cable such
that it is located well away from any drive input power or motor wiring.
Also take care to route the cable away from any sharp edges or positions
where it may be pinched.
8. Take a moment to verify that the interface and all primary and secondary
network cables have sufficient clearance from drives, motors, or power-
carrying electrical wiring.
9. Turn the power sources to all connected drives ON, and verify that the
drives function properly. If the drives do not appear to power up, or do not
function properly, immediately turn power OFF. Repeat steps 1 and 2 to
remove all power from the drives. Then, verify all connections. Contact
ICC or your local Toshiba representative for assistance if the problem
persists.