Filter
Top Products
79
Getting Started
Turning off the computer
Configuring Standby mode options
You can place the computer into Standby mode by either pressing
the power button or closing the display panel. You can also specify
an amount of time after which the computer automatically goes into
Standby mode.
To use any of these methods, you may first need to enable them in
Toshiba’s Power Saver utility.
1 Click Start, Control Panel, and then Performance and
Maintenance.
2 Click the TOSHIBA Power Saver icon.
3 Click the Setup Actions tab.
4 Select Standby for the options you want.
These options are set separately for how they operate while the
computer is running on battery power or while connected to AC
power.
❖ When I press the power button
Set this option to Standby if you want the computer to go
into Standby mode when you press the power button.
❖ When I close the lid
Set this option to Standby if you want the computer to go
into Standby mode when you close the display panel.
5 Click Apply.
6 Click OK.
For more information about the Power Saver utility, see “TOSHIBA
Power Saver” on page 134.
Once the computer is configured, you can place it into Standby
mode by either pressing the power button or closing the display
panel, depending on the Standby options set.
Starting again from Standby mode
To start up the computer from Standby mode, press the power
button until the ON/OFF light glows green. The computer returns to
the screen(s) you were using.
If you place the computer in Standby mode by closing the display
panel, you can start it again by opening the display panel.
NOTE
NOTE