Filter
Top Products
4 Replacement Procedures 4.2 HDD
4. Remove the HDD pack by pulling on the tab attached to the pack, following the
direction of the arrows.
NOTE: Do not disassemble the HDD pack when it is working normally. Disassemble
or replace the HDD pack only if it fails.
5. Place the HDD pack on a flat surface (such as a desk), and remove the two M3x4
black flat head screws with M3x4 black head screws.
6. Place the HDD pack on a flat surface (such as a desk), and remove the chassis.
M3x4 black
flat head screw
HDD Chassis
HDD
M3x4 black
flat head screw
Figure 4-6 Removing the HDD chassis
CAUTION: Do not apply pressure to the top or bottom of the drive.
4-16 Satellite M200/M205 / Satellite Pro M200/ EQUIUM M200/ SATEGO M200 Maintenance Manual