Filter
Top Products
2. PRINTER SETUP
EO1-33029
2.7 Loading the Media
2- 9
2.7.2 Installing the Supply
Holder Unit onto the
Supply Holder Frame
2.7.3 Loading Media into
the Printer
1.
Insert the assembled Supply Holder Unit into the rear notches of the
Supply Holder Frame as shown in the diagram below.
2.
Now feed the media from the bottom of the media roll into the media
slot at the rear of the printer as shown.
The following paragraphs outlines how to properly install the media into
the printer from the Supply Holder Unit that has been installed in the
previous steps.
1.
Raise the Top Cover as shown in the diagram below.
CAUTION!
The reassembled Supply
Holder Unit and media roll
may be quite heavy, so
be careful not to pinch
y
our fingers when
installing the Supply
Holder Unit onto the
Supply Holder Frame.
NOTE:
M
ake sure that the brass
bushings of the Supply Shaft
are seated into the notches so
that the entire Supply Holder
Unit rotates smoothly.
Rear Notch
Supply Holder Frame
Brass Bushing
Rear Notch
Top Cover