Filter
Top Products
APPENDIX 4 SYSTEM MODE
EO1-33029
A4.3 Self-Diagnostic Test
A4- 3
A4.3 Self-Diagnostic
Test
The Self-Diagnostic Test contains the following sub menus:
While pressing the
[FEED]
and
[PAUSE]
keys at the same time, turn
on the printer. Hold both keys until the “<1>DIAG.” Message appears
in the display.
Printing mode selection
Press the
[PAUSE]
key. The type of printing mode can be selected:
“TRANSFR” (Thermal transfer) or “DIRECT” (Thermal direct).
After selecting the printing mode to be used, press the
[PAUSE]
key.
Maintenance counter/parameter settings print out
The printer is ready to print out the Maintenance Counter/Parameter
Settings. Press the
[PAUSE]
key to start.
The printer starts printing out the Maintenance Counter/Parameter
Settings.
After printing is completed, the display returns to “<1>DIAG. Vx.x”.
!',$*9[[
3577<3(75$16)5
0$,17(1$1&(
&217
&+(&.,1*35,17
NOTE:
When using the ribbon, be sure
to select “Thermal Transfer”.
When using thermal media, be
sure to select “Thermal Direct”.
NOTE:
See Section A4.7.1 for the
M
aintenance
Counter/Parameter Settings
p
rint sample and detailed
descriptions for each.
[PAUSE]
[PAUSE]
[FEED]
[FEED]
[RESTART]
[RESTART]
[FEED]
Selection of the printing mode.
Prints out the Maintenance
Counter /Parameter Settings.
Performs a Self-Diagnostic Test,
and prints out the result.
Checks to see if there is any
problem with the print head.
Outline of Self-Diagnostic Test
I
n the Self-Diagnostic Test
mode,
,the printer checks and
p
rints out the printer system
information such as the sensor
or interface, and the
M
aintenance Counter.
It also
p
erforms the print head broken
element check.
3577<3(',5(&7
Thermal transfer
Thermal direct
[RESTART]
[FEED]
NOTE:
Use the
[FEED]
or
[RESTART]
key to select a
desired o
p
tion.
!',$*9[[
$872',$*1267,&
0$,17(1$1&(&217
+($'&+(&.
3577<3(75$16)5
[RESTART]
NOTE:
“x.x” of “DIAG. Vx.x” indicates
firmware version and revision.