Filter
Top Products
APPENDIX 4 SYSTEM MODE
EO1-33029
A4.2 Overview
A4- 2
A4.2 Overview
System Mode consists of four main menus: Self-Diagnostic Test, Printer
Parameter Fine Adjustment, Test Print and PCL Emulation Setting.
While pressing the
[FEED]
and
[PAUSE]
keys at the same time, turn
onon the printer. Hold both keys until “<1>DIAG. Vx.x” message
appears on the display.
NOTE:
• System Mode menus can be
selected with the
[RESTART]
or
[FEED]
key.
• Pressing the
[PAUSE]
key
allows you to enter the sub
menus of each System Mode
menu. Flowcharts of each
menu’s sub menus are provided
on the following pages.
[FEED]
[FEED]
[FEED]
[FEED]
This is the start of the Self-
Diagnostic Test menu.
This is the start of the Printer
Parameter Fine Adjustment menu.
This is the start of the Test Print
menu.
This is the start of the PCL
Emulation menu.
[RESTART]
[RESTART]
[RESTART]
[RESTART]
!',$*9[[
!$'-8676(7
!7(6735,17
!3&/(08/$7,21
IMPORTANT!
I
f the power is turn ON while
p
ressing and holding the
[FEED]
and
[PAUSE]
keys at
the same time, the printer will
enter the
System Mode
intended for Service
Personnel.
I
n addition to the menus shown
in the chart on the
right,
the
f
ollowing menus are also
displayed in the System Mode
f
or Service Personnel:
<2>PARAMETER SET
<5>SENSOR ADJ.
<6>RAM CLEAR
<7>IP ADDRESS
Please do not change the
p
arameter settings for these
items, as doing so may cause
the printer to malfunction.
I
f you should accidentally
enter the System Mode for
Service Personnel, just turn
the power off. If you should
change the settings by
accident and the printer
malfunctions, please contact
y
our nearest TOSHIBA TEC
service representative.