Filter
Top Products
38
How to see the internal states from indicators
There are three indicators that inform of the internal states of the projector. The internal states can be
known by how the indicators are lighting. Check the followings, and if there is any problem, stop to use
the projector and be sure to unplug the power plug. Then, contact a repair/customer front of Mitsubishi
Electric Corporation.
On in red
On in red
On in
green
On in
orange
POWER
LAMP TEMP STATE REMARK
On in
orange
Blinking
in red
Off
Off
Off
On in red
Replace the light-source lamp to a new
one. Purchase a light-source lamp from
the delivery agent of the projector.
• Press POWER button after POWER
indicator has ceased blinking.
If this operation is repeated several times and the
light-source lamp still does not come on, replace
the lamp to a new one. Ask the delivery agent of the
projector or a repair/customer front of Mitsubishi
Electric Corporation about purchase of the lamp.
The interior of the projector is very hot.
• The intake vent and/or exhaust vent is blocked
with something.
• The projector is used at a very hot place such as
outlet of heating air.
• The air filter is foul.
The protection circuit is working, or
The lamp is not normal.
(When power is turned off normally, this indication appears,
and this is not a failure.)
Countermeasure
• Remove those things with which the
vent is blocked.
• Relocate the projector.
• Clean the filter.
Indicating replacement of the lamp (Used about 1000
hours* in total; Power is "ON".)
Indicating replacement of the lamp (Used about 1000
hours* in total; Power is "OFF".)
Indicating replacement of the lamp (Used about 1500
hours* in total)
On in orange
On in green
Blinking in green
Blinking in orange
POWER LAMP TEMP STATE REMARK
Power "ON" (usually).
Lamp standby state. Power can not be turned "OFF".
Lamp is being cleaned.
Power can not be turned "ON".
Standby state.
OffOff
If the projector is not normal:
When the projector is normal:
LAMP indicator
TEMP(temperature) indicator
POWER indicator
ENTER
LAMP
TEMP
MENU/EXIT
POWER
INDICATORS
Kensington Lock
This projector has a Kensington Security Standard connector for use with a Kensington MicroSaver Security
System. Refer to the information that came with the Kensington System for instructions on how to use it to
secure the projector. Please contact to Kensington Technology Group as shown below.
Kensington Technology Group
2855 Campus Drive
San Mateo, CA 94403, U.S.A.
Phone : (650)572-2700 Fax : (650)572-9675