Toshiba TDP-MT500 Projector User Manual


 
39
44.5
199
53.5
33.5
181
168
254
28
166
28
167
1616
280
9
251
308
235
66
96
108
Screen
Projector
Screen
Projector
WHEN ASKING INSTALLATION WORK
In the case of suspending the projector from
ceiling and viewing the projected images from
the front side:
When suspending the projector from ceiling, use the
separately sold dedicated metal bracket (see Page 38).
Also, be sure to ask a special worker who received train-
ing of the installation work to do the work. Consult
the delivery agent of the projector about the details of
the installation work.
If the projector is damaged by using any other suspension
bracket than the dedicated one or due to any problem of the
environment in which the suspension metal bracket is in-
stalled, Mitsubishi Electric Corporation will not compensate
the damage even if the product is still under warranty.
Dimensional drawings (for references)
In the case of the suspension from ceiling, set the projection
method in the setting menu to Ceiling suspension. Refer
to Page 27 for the detail.
Ask the installation worker to provide a power breaker for
the projector. When the projector is not used, be sure to turn
off the main power for the projector with the breaker.
Where the projector is suspended from ceiling, the bright-
ness of the projected images may be less brighter than where
it is set on floor. However, this is not a failure.
Do not install the projector where its exhaust vent is directly
exposed to the wind from an air conditioner or the like. Such
installation may cause failures of the projector.
Do not install the projector near a fire alarm, because hot air
is exhausted form the vent of the projector.
In the case of installing the projector so that the
picture images are projected onto a semitranspar-
ent screen and viewed them from the rear side of
the screen:
When installing the projector, be sure to ask a special
worker who received training of the installation work.
Consult the delivery agent of the projector about the
details of the installation work.
When viewing projected images from the rear side of
the screen, set the projection method in the setting
menu to Rear. Refer to Page 27 for the detail.