NC200
Cloud Camera, 300Mbps Wi-Fi
Static IP: Select this option when a static or fixed IP address is obtained for the camera. A
static IP address will ease your access to the camera in the future. Add your camera’s static
IP information to your router to avoid IP conflicts.
MAC Address: Displays the Ethernet MAC address of the camera. The MAC address is
read-only.
IP Address: Enter a fixed IP address for the camera in dotted-decimal notation.
Subnet Mask: Enter the subnet mask in dotted-decimal notation. The default value is
“255.255.255.0.”
Default Gateway: Enter the default gateway in dotted-decimal notation.
Primary DNS Server: Enter a DNS address in dotted-decimal notation.
Secondary DNS Server: Enter a DNS address in dotted-decimal notation.
PPPoE (Point to Point Protocol over Ethernet)
This camera is a PPPoE enabled one. It can directly connect to the xDSL, however, it should be
set up in a LAN environment to configure the PPPoE information first, and then connect to the
xDSL modem. Power on again, and the camera will dial on to the ISP to get a dynamic IP address
and connect to the WAN through the xDSL modem. In this case, you need to use a domain name
to log in to the camera. For details, please refer to 3.4.6 Advanced → DDNS
.
20