NC200
Cloud Camera, 300Mbps Wi-Fi
PPPoE: To enable or disable the PPPoE service here.
Status: Displays the PPPoE connection status.
Username: Enter the username for PPPoE service provided by your ISP.
Password: Enter the password for PPPoE service provided by your ISP.
HTTP (Hypertext Transfer Protocol)
This feature allows you to access and manage your camera from a remote location over the
Internet. Web browser access normally uses the standard HTTP service port 80. This camera's
default remote management web port number is 80. For greater security, you can change the port
to a custom one.
When you have set the HTTP port number to a number other than 80, a corresponding port must
be opened on the router.
Access the camera by typing the IP address of the camera on the Web browser as follows: for
example, when HTTP port number is set to 2000 and the IP address of your camera is set to
192.168.1.100, you should type in http://192.168.1.100:2000 instead of http://192.168.1.100 to
access the camera.
HTTP Port: The default value is 80. If you want to use a port number other than 80, enter a
port number between 1 and 65535.
UPnP (Universal Plug and Play)
This camera is an UPnP enabled one. This means the camera can dynamically join a network,
obtain an IP address. In turn, the camera can leave a network smoothly and automatically when it
is no longer in use. UPnP is enabled by default; if you don’t want to use this function, just select
the Disable option.
UPnP Port Forwarding: To enable or disable the UPnP Port Forwarding service here. If this
function is enabled and your router supports UPnP, the cameras and router can communicate
with each other so that the router knows which ports are used by which camera.
UPnP Name: Displays the camera name.
21