TP-Link TL-SL2210WEB/TL-SL2218WEB Switch User Manual


 
46
Gigabit Uplink Web Smart Switch
Port TrunkingFigure 6-43
Trunk
¾
: The Trunk number.
Member
¾
: Select the member of the Trunk here. Each group has 4 optional ports to
compose a Trunk.
Storm Control
¾
: configure the storm control for the Trunk here. All member ports
of the Trunk share the same settings. Subfield of the Storm Control are the same as
that of the port storm control, see phase 6.3.2.4 for details.
Select All
¾
: Select all Trunk members in the list.
Clean Up
¾
: Clean up the Trunk member list.
Note:
Each Trunk should contains 2 to 4 ports (If a Trunk is submitted with 0 member port,
it indicates to delete the Trunk).
SFP and 1000Mbps port in TL-SL2210WEB/TL-SL2218WEB/TL-SL2428WEB/TL-
SL2452WEB, is not able to be the Trunk member.
Trunks cannot be set if the switch is in MTU VLAN mode.

Priority setting contains four topics: priority mode, port-based priority, port default
priority and 802.1p priority.
Because dynamic menu is adopted, only the pages corresponding to current priority
mode are revealed. If the parameters of other priority modes are to be configured,
select the corresponding priority mode in “Priority Mode” page first.

This page is shown below:
Priority ModeFigure 6-44
Web Management