Filter
Top Products
50
Gigabit Uplink Web Smart Switch
Troubleshooting
The Power LED should be lit up when the power system works normally. If the
Power LED worked abnormally, please take the following steps:
Make sure that the power cable is connected properly, and the power contact 1.
is normal.
Make sure the voltage of the power supply meets the requirement of the input 2.
voltage of the Switch.
You are recommended to check the following items:
Check every port LED on the Switch and make sure the cable is installed 1.
properly.
Try another port on the Switch and make sure the cable meets the requirement 2.
and works normally.
Turn off the power. After a while, turn on the power again.3.
Make sure the IP address of your PC is set within the subnet of the Switch.4.
If you still cannot access the conguration page, please restore the Switch to 5.
its factory defaults. Then the IP address should be set as 192.168.0.x ("x" is
any number from 2 to 254) and Subnet Mask as 255.255.255.0.