Filter
Top Products
TVP-221H User’s Guide
30
iii. Manual: Enables gatekeeper co-operation in manual
operation (the gatekeeper address must be properly
assigned).
The following fields must be filled in when Gate Keeper Mode is set to
manual.
2. Gate Keeper Address: Specify the gatekeeper address when configured
to manual mode. When auto mode is desired, this field should be set to
auto
3. Allow Calls Without Gate Keeper: This field is to inform the H.323
stack to allow calls when the endpoint is not registered with a gatekeeper.
4. Registration Type: This field is to set the endpoint registration type.
This specifies how the endpoint will register itself with the gatekeeper.
5. Max Registration Retries: This field is to control how many registration
attempts will be made before the endpoint considers itself to have failed
registration.
6. Time To Live: Do not have to set this because GK to perform this
function. Every x seconds will check to see if it is alive
7. Endpoint Prefix: This command is used to set the H.323 prefix that the
TVP-221H uses when registering to an H.323 gatekeeper.
8. Terminal ID: To specify GW’s ID.
9. GateKeeper ID: To specify Gate Keeper’s ID.
You'll have to reboot the system to make your changes take effect!