Filter
Top Products
TVP-221H User’s Guide
23
System Status
Select Home
In order to view the System Status page, please navigate to Home.
The System Status page will display the following parameters:
Firmware Version
• TVP-221H VoIP Gateway Version:
• Boot Loader Version:
• RTOS Version:
• H.323 Stack Version:
• DSP image Version:
• TSG Version:
LAN Interface Parameters
• IP precedence:
• Ethernet MAC address:
• IP address:
• Subnet mask:
• Default gateway:
4.2 Internet Access
The TVP-221H can be configured with a fixed IP address, subnet mask and
default gateway (typically a router). The TVP-221H can also be setup as a DHCP
Client if your network has a DHCP Server (typically a router). Additionally, the
TVP-221H can also be configured to use PPPoE. With PPPoE, you will have a
Dynamic IP but combined with Dynamic DNS, the TVP-221H will automatically
notify DynDNS of your changing IP Address and DynDNS will in turn, map it to
your registered Domain Name. Consult your network manager to obtain a unique
and static IP address for the TVP-221H, the IP subnet mask and default gateway
of your network, and fill out the work sheet in Appendix D before configuring the
gateway..
The first time you connect the TVP-221H for configuration, you will need to
connect to it under the same LAN segment to set the Fixed IP or DHCP, PPPoE
clients. The default TVP-221H IP address is 192.168.0.1. To configure the TVP-
221H, insert one end of the Ethernet cable into the RJ45 port on the rear panel of
the TVP-221H and other end directly to your PC Terminal. The TVP-221H
supports auto MDIX so you do not have to worry about the cable. Any Cat 3 or 5
cable will be sufficient. Once Internet Access has been set up, disconnect the
TVP-221H from the configuring PC and connect it directly to your ADSL Cable
Modem or place it under a router as configured.