Filter
Top Products
TVP-221H User’s Guide
TVP-221H configuration (ADSL PPPoE connection) on site A
Web Configuration
Telnet / Console
Local (from PC in same Segment)
Open your browser
1. Enter 192.168.0.1
2. You will be prompted for
Username and Password. Default
Username and Password are
“admin” and “123” respectively.
Web Configuration of Internet Access
Internet Access / Fixed IP
Enter Fixed IP (192.168.0.20,
Subnet Mask(255.255.255.0),
Default Gateway 192.168.0.254.
3. Click on ‘Save”
67
Console
Connect RS-232 to TVP-221H & PC
Open Hyper Terminal
Input parameters:
Baud rate 19,200
Number of data bit 8
Parity check None
Number of stop bit 1
Flow control None
Enter “123”
Telnet (from PC in same Segment)
From Windows command prompt
Enter “telnet 192.168.0.1”
Enter Username “admin”
Enter “123”
net set ip 192.168.0.20
net set mask 255.255.255.0
net set gateway 192.168.0.254
Once Internet Access is setup, you could
choose to reboot the TVP-221H, and then
use a PC in the same segment and with a
web browser, access theTVP-221H:
If using the Router’s DHCP Server, make
sure the routers DHCP Server is on and that
the configuring PC and TVP-221H are
DHCP Client enabled.
From the local connection, you could
continue on setting up the dial plan.
However you could choose to reboot,
If you would like your PC and / or TVP-221H
to have a Fixed IP, Make sure that the their
IP’s do not conflict with the range of IP’s
allocated with the Routers DHCP Server.
Enter “net reset”
Enter “telnet 192.168.0.20”
Enter “telnet tvp1.dyndns.org”
Enter Username “admin”
Enter “123”
Connect your TVP-221H and a PC
directly to your router making sure
they are in the same LAN segment.
From the windows command prompt:
Or from a remote computer
You would then continue as below:
If you are trying to access the TVP-221H
from a PC in the same segment as the TVP-
221H (LAN), Open your browser and enter
1. Enter 192.168.0.20
If you would like to access the TVP-221H
from the WAN side, from a remote PC with
Internet Access:
2. Enter tvp1.dyndns.org
You will be prompted for Username and
Password. Default Username and Password
are “admin” and “123” respectively.
You could then continue as below: