Filter
Top Products
33
Lockout in Scanning Mode
If the scanner keeps stopping on a particular channel due to noise or frequent transmissions,
you may want to keep that channel from scanning.
1. Wait until the scanner stops on the channel.
2. Then press L/O.
3. The scanner immediately resumes scanning because the locked out channel is no longer
in the scanning sequence.
Lockout Tips Write down your locked-out channels and put in a convenient place in
case you need to restore them.
Restoring a Locked-out Channel
1. Press ▲/HOLD.
2. Select a locked out channel.
a. Enter the channel number using the keypad.
b. Then press ▲/HOLD again.
3. Press L/O to unlock the channel. The L/O disappears.
Restoring All Locked-out Channels
You can restore all locked-out channels in a bank only when a bank is selected for scan. If
you have deselected a bank and you want to restore all of its locked-out channels using the
steps below, you must press SCAN and then enter the number of the bank on your keypad.
1. Press ▲/HOLD.
Note: You must be in Hold mode before restoring all locked-out
channels.
2. Press and hold L/O for about 2 seconds.
You will hear two beeps when all the channels have been
restored.
BC785D 11/8/2 1:01 PM Page 33