Filter
Top Products
10
» Control Panel on the Projector
1 2 3 4
7
10
8
14
12
5
6
9
11
13
15
16
1. LAMP BUTTON:
Light On: Indicates the lamp has been used for more than 1900
hours.
Blinking: Indicates the lamp has been used for more than 2000
hours. Please change the lamp.
2. TEMP BUTTON
Blinking: Indicates the temperature inside the projector is
abnormally high.
3. POWER BUTTON
Light On: During projection.
4. STANDBY BUTTON
Light On: In stand by mode.
Blinking: In cool down mode.
5. RGB BUTTON
Use this button to select a device connected to the [RGB1],
[RGB2] or [RGB3] terminals.
6. VIDEO BUTTON
Use this button to select a device such as a video connected to
the [VIDEO IN] terminal ([VIDEO] or [Y/C] Input terminal) of
the projector.
7. POWER BUTTON
When this projector is in standby mode, pressing this button
for more than 1 second will turn the projector on and cause the
[POWER] indicator to light up. Press it one second or more
again, and the projector goes into the cool down mode and finally
into stand by mode.
• The [POWER] button will not work within approximately 1
minute of the light-source lamp being turned on. Hence wait
about 1 minute before pressing.
8. SVC BUTTON
This button is to be used by Vidikron Service Technician.
9. V-KEYSTONE BUTTONS
Use this button to remove the vertical trapezoidal distortion of the
image projected on the screen.
10. H-KEYSTONE BUTTONS
Use this button to remove the horizontal trapezoidal distortion of
the image projected on the screen.
11. MENU BUTTON
Use this button to enter or exit the menu mode. When the main
menu is displayed, pressing this button will cause the menu to
disappear.
12. EXIT BUTTON
Press this button to display the previous menu (For example,
from sub menu to main menu). Pressing this button when the
main menu is displayed will erase the menu.
13. CURSOR BUTTON
These buttons are used in the menu mode to select an item, adjust
the value etc.
14. ENTER BUTTON
Press this button to show the next menu (For example, from main
menu to sub-menu). It is also used when [ENTER] is displayed
against an item on the menu screen, or to choose the “Reset”
option etc.
15. KEY RESET BUTTON
This [RESET] button only works as a reset button for the [SVC],
[V-KEYSTONE] and [H-KEYSTONE] adjustments done on
the control panel and the [SVC], [V-KEYSTONE], and [H-
KEYSTONE] adjustments done on the remote control. When
adjusting the volume, keystone or digital zoom (when the setting
is displayed on the screen) the adjusted value is reset to that
which was set when the projector was shipped from the factory.
This button does not work for the menu (submenu) items.
16. MUTE BUTTON
Use this button to temporarily halt the audio and video output.
Press again to resume.
CONTROLS AND FEATURES