Filter
Top Products
4
SAFETY PRECAUTIONS
– Slots and openings in the cabinet are provided for ventilation.
These ensure reliable operation of the product and protect it from
overheating. These openings must not be blocked or covered.
(The openings should never be blocked by placing the product
on bed, sofa, rug, or similar surface. It should not be placed in
a built-in installation such as a bookcase or rack unless proper
ventilation is provided and the manufacturer’s instructions have
been adhered to.)
For proper ventilation, separate the product from other equipment,
which may prevent ventilation and keep a distance of more than
11-7/8” (30 cm).
– This product should be operated only with the type of power
source indicated on the label. If you are not sure of the type of
power supply to your home, consult your product dealer or local
power company.
– This product is equipped with a three-wire plug. This plug will
fit only into a grounded power outlet. If you are unable to insert
the plug into the outlet, contact your electrician to install the
proper outlet. Do not defeat the safety purpose of the grounded
plug.
– Power-supply cords should be routed so that they are not likely
to be walked on or pinched by items placed upon or against them.
Pay particular attention to cords at doors, plugs, receptacles, and
the point where they exit from the product.
– For added protection of this product during a lightning storm,
or when it is left unattended and unused for long periods of time,
unplug it from the wall outlet and disconnect the cable system.
This will prevent damage to the product due to lightning and
power line surges.
– Do not overload wall outlets, extension cords, or convenience
receptacles on other equipment as this can result in a risk of fire
or electric shock.
– Never push objects of any kind into this product through
openings as they may touch dangerous voltage points or short out
parts that could result in a fire or electric shock. Never spill liquid
of any kind on the product.
– Do not attempt to service this product yourself as opening or
removing covers may expose you to dangerous voltages and other
hazards. Refer all service to qualified service personnel.
– Unplug this product from the wall outlet and refer service to
qualified service personnel under the following conditions:
a) When the power supply cord or plug is damaged.
b) If liquid has been spilled, or objects have fallen on the
product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by following the
operating instructions. Adjust only those controls that are covered
by the Operation Manual, as an improper adjustment of controls
may result in damage and will often require extensive work by a
qualified technician to restore the product to normal operation.
e) If the product has been dropped or damaged in any way.
f) When the product exhibits a distinct change in performance
- this indicates a need for service.
– When replacement parts are required, be sure the service
technician has used replacement parts specified by the
manufacturer or with same characteristics as the original part.
Unauthorized substitutions may result in fire, electric shock, or
other hazards.
– Upon completion of any service or repairs to this product, ask
the service technician to perform safety checks to determine that
the product is in proper operating condition.
– The product should be placed more than one foot away from
heat sources such as radiators, heat registers, stoves, and other
products (including amplifiers) that produce heat.
– When connecting other products such as VCR’s, and personal
computers, you should turn off the power of this product for
protection against electric shock.
– Do not place combustibles behind the cooling fan. For example,
cloth, paper, matches, aerosol cans or gas lighters that present
special hazards when over heated.
– Do not look into the projection lens while the illumination lamp
is turned on. Exposure of your eyes to the strong light can result
in impaired eyesight.
– Do not look into the inside of this unit through vents (ventilation
holes), etc. Do not look at the illumination lamp directly by
opening the cabinet while the illumination lamp is turned on. The
illumination lamp also contains ultraviolet rays and the light is so
powerful that your eyesight can be impaired.
– Do not drop, hit, or damage the light-source lamp (lamp unit)
in any way. It may cause the light-source lamp to break and lead
to injuries. Do not use a damaged light-source lamp. If the light-
source lamp is broken, ask your dealer to repair it. Fragments
from a broken light-source lamp may cause injuries.
– The light-source lamp used in this projector is a high pressure
mercury lamp. Be careful when disposing of the light-source
lamp. If anything is unclear, please consult your dealer.
– Do not ceiling-mount the projector to a place which tends to
vibrate; otherwise, the attaching fixture of the projector could be
broken by the vibration, possibly causing it to fall or overturn,
which could lead to personal injury.
– Use only the accessory cord designed for this product to prevent
shock. The power supply voltage rating of this product is AC 120
V, AC 100 V - AC 240 V, the power cord attached conforms to
the following power supply voltage. Use only the power cord
designated by our dealer to ensure Safety and EMC. When it
is used by other power supply voltage, power cable must be
changed. Ensure that the power cable used for the projector is the
correct type for the AC outlet in your country.
Consult your product dealer.
*DO NOT allow any unqualified person to install the unit.
Be sure to ask your dealer to install the unit (e.g. attaching it
to the ceiling) since special technical knowledge and skills are
required for installation.
If installation is performed by an unqualified person, it may
cause personal injury or electrical shock.