Filter
Top Products
■ After installing a new lamp, reset the lamp time counter inside the projector when this is done. A new count will start.
If the display of the accumulated lamp time has reached 2000 hours, the projector will not work (lamp does not light up)
unless the lamp time is reset.
RESETTING THE LAMP TIME (FOR SERVICE ONLY)
1. Insert the power cord into the wall outlet
• The [STAND BY] indicator lights up when the main power is inputted.
2. Press the [EXIT], [MUTE], [KEY RESET] buttons on the remote control sequentially, then press SVC for 2
seconds or more
• The [STAND BY] and [ON] indicators alternately blink about every approximately 3 seconds. After blinking stops, lamp time resets
and the projector returns to the stand-by state ([STAND BY] indicator lights up).
To ensure the lamp hours have been reset
The lamp time can be checked via the “Lamp hours” item in the “Signal Info” menu.
Caution for reset work
Reset the lamp hours only when you have replaced the lamp.
Never reset it while the lamp is still in use, otherwise the approximate standard for gauging replacement time may
be inaccurate, lamp performance may suffer and lamp blow-out may also occur.
41