Filter
Top Products
Vidikron PlasmaView Owner’s Operating Manual 11
PRE
L
IMINAR
Y
3.1
Remote Control
To install batteries in the remote control:
1. Remove the battery cover from the remote control.
2. Insert the two (2), AAA-size batteries included with
the remote control. Ensure that the polarities
correctly match the
and markings inside the
battery compartment.
3. Replace the battery cover.
Notes on Batteries• When installing batteries, make sure that the battery polarities are correct.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
Notes on Remote Control
Operation
The remote control can be used to control the PlasmaView within the ranges shown in Figure
3-1.
Figure 3-1. Available Range of the Remote Control
3Installation
Approx.
23 ft (7m)