Filter
Top Products
Operation
Vidikron PlasmaView Owner’s Operating Manual 31
PRE
L
IMINAR
Y
Memory Setting: Choose Memory Setting from the Picture Adjust menu to store the current
input and image quality settings in one of six memory locations. These memory locations are
global (that is, shared by all inputs). You can recall these settings at a later time, without
manually recreating them.
You should save changes to any of the following settings to a picture memory; otherwise
they will be lost when a new input source is selected:
• Contrast/Brightness
• Color saturation/Tint
• Sharpness
•Gamma
• Color temperature and white balance
• Aspect ratio
To store settings to a picture memory:
1. Select Memory Setting from the Picture Adjust menu.
2. Use the left- and/or right-arrow buttons to select a memory location (1 through 6).
3. Press MENU on the remote control. The Picture Memory screen appears.
4. Use the left- and/or right-arrow buttons to select SET, then press MENU.
5. If desired, enter a brief note (up to 15 characters long) describing the stored settings. To
do this:
a Use the left- and/or right-arrow buttons to select NOTE, then press MENU.
b Use the up- and/or down-arrow buttons to select the character. Use the left- and/or right-arrow
buttons to change the cursor position. Press EXIT to insert a space or delete a character at the
current position.
c When you have finished entering the note, press MENU.
To recall a picture memory setting, perform Steps 1 and 2 above.
SEL.
MEMORY SETTING
1 / 2
MEMORY1 SET RESET
INPUT : DVD/HD1
SIGNAL : 480P
NOTE : DVD/STAR WARS
MEMORY2
INPUT : —
SIGNAL : —
NOTE : —
MEMORY3
INPUT : —
SIGNAL : —
NOTE : —
NEXT PAGE
RETURN
EXIT
MENU/ENTER
OK