ViewSonic PJ500 Projector User Manual


 
7
ViewSonic PJ500
Cabling
Refer to the table below for connecting each terminal of the projector to a device.
NOTE:
Before connecting, read the instruction manuals of the devices to be connected, and make sure that the projector is
compatible with the device(s).
Securely tighten the screws on the connectors.
For some RGB input modes, the optional Mac adapter is necessary.
Some computers may have multiple display screen modes. You may not be able to use some of the modes with this
projector.
Power Connection
Use the correct power cord supplied with your projector. Connect the AC inlet of the projector to the
power outlet as shown in the graphic below.
Figure 7: Power Cord Connect
Table 2: Cabling
Function Terminal Cable
Analog RGB input RGB Accessory RGB cable or optional
RGB cable with D-sub 15-pin shrink
jack and inch thread screws
RS-232C communication CONTROL Optional RS-232C cable
Component video input VIDEO Y
VIDEO C
B
/P
B
VIDEO C
R
/P
R
Accessory component video cable
S-video input S-VIDEO Accessory S-video cable with mini
DIN 4-pin jack
Video input/
Audio input
VIDEO
AUDIO (L)
AUDIO (R)
Accessory video/audio cable with
RCA jacks
Audio Input 3.5 mm to mini-jack L/R Optional
Warnings
Incorrect connections could result in fire or electrical shock.
Before connecting, turn off all devices to be connected.
Use the cables that are packaged with the product. Refer to page 27.
See “Power Cord Safety Guidelines” on page 26.