Filter
Top Products
Pen display components
page 8
Rear view
Next step:
Installation
. See page 9.
Video, USB, and
power connectors
Kensington security slot
Allows easy attachment of
a security cable.
Pen tether attachment points
If you will be using the pen tether, use
the tether attachment ring and small
thumb screw to connect it to one of
four attachment points located on the
back of the unit.
Stand adjustment lever
Pull this lever up to adjust
the stand. Release the
lever to lock the stand in
place.
Important: Be sure to adjust the stand to the low tilt position before packaging the DTF-521/PL-521.
If you do not close the stand, the notched mechanism may be damaged during transportation and
storage. Do not lift the unit by the stand; this may damage the stand mechanism. When lifting or
moving the pen display, always do so by grasping the main body casing.
C
AUTION
Be careful to avoid catching your finger in the
gap of the movable portion of the stand.
Stand
The stand can be used
to adjust the tilt angle of
the unit.
Pen storage compartment
F
or storage, insert one end of the pen into either side of the storage compartment.
Then gently press the other end of the pen into the compartment.
F
or removal, press in on either end of the pen. This will pop the opposite end of the
pen out of the compartment. You can then remove the pen.
DTF521_Manual.fm Page 8 Tuesday, February 28, 2006 10:36 AM