Filter
Top Products
Installation
page 9
INSTALLATION
System requirements
Before installing the DTF-521/PL-521 pen display, make sure your computer meets the following
system requirements:
•
PC.
Windows XP, XP x64, 2000, Me, or 98SE. VGA video connector, available USB port, and
CD-ROM drive.
•
Macintosh.
OS X, v10.2.8 or greater. VGA video connector, available USB port, and
CD-ROM drive.
Note:
The DTF-521/PL-521 can be used alone or with another display. You may connect a second
VGA device such as a monitor or LCD projector to the DTF-521/PL-521
ANALOG
RGB
OUT port.
When using this port, the second device will mirror the image on the pen display. Complete the pen
display installation before connecting a projection device to the unit.
Depending on the capabilities of your video card and operating system, you may be able to set up
the DTF-521/PL-521 as a mirrored, extended, or independent display. Refer to your video card
documentation for more information on its capabilities.
When you are working with more than one monitor, the DTF-521/PL-521 will map to the monitors
based upon how your system is configured. By default, if you are in mirror mode, the pen tablet will
map to the entire space on each display or monitor. Please refer to your hardware and operating
system documentation for details on configuring your computer and operating system for use with
multiple monitors.
There are two primary steps to the installation process:
• Step 1: LCD monitor installation
• Step 2: Pen tablet installation
Be sure to follow ALL instructions carefully.
DTF521_Manual.fm Page 9 Tuesday, February 28, 2006 10:36 AM