Filter
Top Products
Installation
page 11
LCD monitor cabling diagram
DTF-521/PL-521, rear view
– B –
DC IN
(12V)
– A –
VGA cable
Video card
Rear panel of your computer
ANALOG RGB OUT
Do not attach the USB data
cable until instructed to do so.
Power adapter – C –
To AC outlet
C
AUTION
Use only the power adapter that came with the DTF-521/PL-521; use of an improper power
adapter may damage the unit.
Do not connect or disconnect the video or power cables while the DTF-521/PL-521 or
your computer are turned on – this can damage the LCD monitor or computer video card.
Make sure that the display refresh rate does not exceed 70 Hz for XGA mode, or 75 Hz
for other modes.
ANALOG RGB IN
VGA port
The ANALOG RGB OUT port is used to
connect a second VGA device such as
a projector or monitor that mirrors the
pen display. Be sure to fully install the
pen display hardware and software
before connecting a projection device
to the unit. Do not connect or
disconnect any cable while the pen
display or your computer are turned
on.
DTF521_Manual.fm Page 11 Tuesday, February 28, 2006 10:36 AM