Filter
Top Products
3. Quick Start
This Quick Start procedure is included primarily to provide a quick
demonstration of IPS capabilities. In order to take full advantage of
the complete range of features provided by this unit, it is strongly
recommended that you should complete the Installation and
Configuration sections after completing the Quick Start procedure.
3.1. Hardware Installation
Make the following connections as described in Figure 3.1.
1. Switched AC Outlet: Connect the power cable from the
switched device to the Switched AC outlet on the back panel
of the IPS Master Unit.
2. Power Inlet: Connect the supplied power cable to the Power
Inlet on the back panel of the IPS Master Unit. Connect the
other end of the power cable to an appropriate power supply.
CAUTION: Make certain to review the safety
precautions listed in Section 4.1.
3. 10BaseT (Network) Port: Connect your 10Base-T or
100Base-T network interface to the IPS Network Port. For
more information, please refer to Section 4.4.
Note: The IPS features a 10Base-T Interface. When
connecting to a 100Base-T interface, most router
switches will autosense to determine if the device is
100Base-T or 10Base-T, and then configure the
network interface accordingly. If your router switch
does not autosense, the network interface port must be
manually set to 10Base-T.
4. Network Cable: Your 10Base-T or 100Base-T network
interface.