Filter
Top Products
For Optional Satellite Units Only
Steps 8 through 13 apply only to installations that include optional
IPS Satellite Units. If your installation does not include satellite
units, please skip steps 8 through 13.
8. Link Port (Optional): An RJ-11 jack, which is used to link
IPS Satellite units to the IPS Master Unit.
Note: The IPS-15 Master Unit and Satellite Units
should not be placed more than 100 feet apart.
9. RJ-11 Cable (Optional): Use standard, straight wired, six
conductor RJ-11 cable, such as WTI's AC-10, AC-15 or
AC-25 cables. For a description of straight wired RJ11
cables, please refer to Appendix A.2.
10. Satellite Unit Link Ports (Optional): A pair of RJ-11 Jacks,
which are used to connect the Satellite unit to the IPS Master
Unit. If additional Satellite units are to be installed, the Link
Port is also used to connect to the next Satellite unit in the
chain.
11. Connect Switched Device to Satellite Unit (Optional):
Connect the power cable from your switched device to the
Switched AC Outlet on the Satellite Unit's back panel.
12. Satellite Unit Power Inlet (Optional): Use the supplied
power cord to connect the Satellite unit to an appropriate
power source. Make certain to observe the safety warning
listed in Section 4.1.
13. RJ-11 Cable to Link Additional Satellite Units (Optional):
If your installation will include more than one Satellite unit,
repeat items 8 through 12 above for each of the remaining
Satellite Units.