Filter
Top Products
Installation
1–36 975-0046-01-01
To make the neutral connections:
1. Ensure there is only one neutral-to-ground bond in the system. In this
case, it would be in the main AC distribution panel.
2. Connect the neutral (white) wire from the neutral bar in the main AC
distribution panel to one of the neutral terminals in the ACCB.
3. Connect the factory-installed neutral wire (white) in the ACCB to the
NEU1 terminal in the inverter.
4. Connect the neutral (white) wire from the generator and connect it to
one of the neutral terminals in the ACCB.
5. Route and connect a neutral (white) wire from one of the neutral
terminals in the ACCB to the outlet that will be supporting the
AC load.
Important:
Ensure there is only one neutral-to-ground bond in the entire
system. See the Sine Wave Plus Inverter/Charger Owner’s Manual for additional
information regarding the neutral-to-ground bond requirements.
Figure 1-32
Neutral Connections for an On-Grid Application Using Additional Circuit Breakers
in the ACCB Only
1
3
2
4
5