Filter
Top Products
Configuration
14 975-0052-01-01 Rev A
Installing the ICA Software: ICAP
The Inverter Communications Adapter software program
(ICAP) is included on the CD in the ICA package. It allows a
personal computer to operate as a virtual control panel for up
to eight Sine Wave Plus Inverter/Chargers.
For other computer platforms, See “Setting Up a Modem
Connection” on page 21.
Select one of the following methods to install the software:
• Use Autorun (must be enabled on your CDROM drive).
• Manual Start (assumes that Autorun is not enabled on
your CDROM drive).
• Use a Command prompt to initiate the installation
program.
Starting the Setup Program Using Autorun
To install the software with Autorun enabled on your
CDROM drive:
1. Insert the CD into your computer’s CDROM drive. If
autorun has not been disabled for the CDROM in your
computer, the Welcome screen shown in Figure 2-1 will
appear.
Important:
Software levels shown in these illustrations
may not represent the most current version.
Figure 2-1
ICAP Welcome Screen