Filter
Top Products
XES Synergix 8825/8830/8850/8855 Digital Solution User Guide 104
Main Menu (continued)
MOTOR SPEED
The MOTOR SPEED option is for use by the Customer Service Engineer only
and requires the entry of the diagnostic password. It allows the Customer
Service Engineer to adjust the Scanner motor speed and correct
magnification error in the process direction.
If you select this option, the MOTOR SPEED screen is displayed. You
cannot perform any functions in this screen. Press the Exit key to return to
the COMPONENTS TESTS menu screen.
Below is an example of the MOTOR SPEED screen.
LEAD EDGE/TRAIL EDGE
Select the LEAD EDGE/TRAIL EDGE option to execute the lead edge/trail
edge adjustment diagnostic.
To run the LEAD EDGE/TRAIL EDGE diagnostic:
1. Press the Menu key. The MAIN MENU screen is displayed.
2. Press the Next key until DIAGNOSTICS is highlighted.
3. Press the Enter key to select DIAGNOSTICS. The DIAGNOSTICS
menu screen is displayed.
4. Press the Next key until SCANNER DIAGNOSTICS is displayed.
5. Press the Enter key to select SCANNER DIAGNOSTICS. The
SCANNER DIAGNOSTICS menu screen is displayed.
6. Press the Next key until COMPONENT TESTS is highlighted.
7. Press the Enter key to select COMPONENT TESTS. The
COMPONENTS TESTS menu screen is displayed.
8. Press the Enter key to select LEAD EDGE/TRAIL EDGE. The LEAD
EDGE/TRAIL EDGE ADJUSTMENT screen is displayed.
9. Insert a black sheet (8.5 X 11) of paper into the Scanner.
10. Press the Start key to begin the diagnostic. When the diagnostic
completes, the last line of the display is replaced with a status line
indicating PASS or FAIL. The last line may also display as NO
RESPONSE FROM SCANNER if the Scanner does not process the
request within the timeout period.
11. Press the Enter key to return to the COMPONENT TESTS menu screen.
MOTOR SPEED
EXPECTED LENGTH: 610
MEASURED LENGTH: 0
PRESS START TO ADJUST SPEED
LEAD EDGE/TRAIL EDGE
ADJUSTMENT
PRESS START TO BEGIN