Filter
Top Products
XES Synergix 8825/8830/8850/8855 Digital Solution User Guide 48
Special features keys (continued)
Finisher menu options
Below are descriptions of each of the Finisher menu options. Refer to the
Finisher user documentation for additional information on these options.
FOLD PROGRAM
The FOLD PROGRAM option enables you to select one of up to 20 user-
defined programs. The program names are programmed into the finisher
and passed to the Controller when the finisher goes through its power-up
sequence.
OVERLENGTH OPTIONS
The OVERLENGTH OPTIONS option enables you to specify how long
documents (documents over 80 inches long) are handled by the folder. The
choices are NO FOLD and Z-FOLD. If NO FOLD is selected, the long
document will not be folded. If Z-FOLD is selected, the long document will be
Z-FOLDED, but not cross-folded. NO FOLD is the factory default setting.
TAB OPTIONS
The TAB OPTIONS option enables you to override the pre-programmed tab
settings for the selected finishing program. The choices are ALWAYS ON,
ALWAYS OFF, and USE PROGRAM SETTING. USE PROGRAM SETTING
is the factory default setting.
PUNCH OPTIONS
The PUNCH OPTIONS option enables you to override the pre-programmed
hole punch settings for the selected finishing program. The choices are
ALWAYS ON, ALWAYS OFF, and USE PROGRAM SETTING. USE
PROGRAM SETTING is the factory default setting.
FOLD PROGRAM
PROGRAM: USER PROGRAM NAME
OVERLENGTH OPTIONS
OVERLENGTH: NO FOLD
TAB OPTIONS
TAB: USE PROGRAM SETTING
PUNCH OPTIONS
PUNCH: USE PROGRAM SETTING