Filter
Top Products
Loading Paper
Chapter 4: Paper Loading and Orientation ❖ 4-7
3
Slide end guide B (2) out to align it with end guide A (1).
4
Load paper so that it is under both the metal stop tab and
the plastic fill tabs and adjust the side guide to the edge
of the stack as needed. Refer to Figure 4.1 on page 4-8 for
correct paper orientation.
Ensure that all sheets of paper are aligned in the
paper tray. It should not be necessary to fan the
paper before loading it, however if paper feeding
problems occur with some paper, you may want to
remove the paper and lightly fan it.
The type of paper loaded (plain, prepunched,
letterhead, transparency, etc.) must be set using the
Tray 1 Type item in the Control Panel’s Tray Menu
(refer to Chapter 3 of the System Administrator
Guide).