Filter
Top Products
Replacing the Fuser Cartridge/BTR
Chapter 6: Replacing Consumables ❖ 6-5
Replacing the
Fuser Cartridge/
BTR
• The fuser area is extremely hot. Turn the printer OFF
and allow it to cool for 40 minutes before replacing an
existing fuser cartridge.
• Replacing the BTR (Bias Transfer Roll) requires
removing the EP cartridge. Do not expose the EP
cartridge to direct sunlight or artificial light for more
than 15 minutes. Overexposure will permanently
damage the photosensitive imaging drum.
1
Power OFF the printer and disconnect the power cord.
2
Open the rear cover.
3
Let the fuser area cool for 40 minutes.
If the Duplex Module is installed, continue with Step 4 on
page 6-6. Otherwise, skip to Step 5 on page 6-6.