30 www.xilinx.com SP605 Hardware User Guide
UG526 (v1.1.1) February 1, 2010
Chapter 1: SP605 Evaluation Board
10. SFP Module Connector
The board contains a small form-factor pluggable (SFP) connector and cage assembly that
accepts SFP modules. The SFP interface is connected to MGT Bank 123 on the FPGA. The
SFP module serial ID interface is connected to the "SFP" IIC bus (see “14. IIC Bus,” page 35
for more information). The control and status signals for the SFP module are connected to
jumpers and test points as described in Table 1-12. The SFP module connections are shown
in Table 1-13.
Table 1-12: SFP Module Control and Status
SFP Control/Status Signal Board Connection
SFP_TX_FAULT
Test Point J15
High = Fault
Low = Normal Operation
SFP_TX_DISABLE
Jumper J44
Off = SFP Enabled
On = SFP Disabled
SFP_MOD_DETECT
Test Point J16
High = Module Not Present
Low = Module Present
SFP_RT_SEL
Jumper J22
Jumper Pins 1-2 = Full Bandwidth
Jumper Pins 2-3 = Reduced Bandwidth
SFP_LOS
Test Point J14
High = Loss of Receiver Signal
Low = Normal Operation
Table 1-13: SFP Module Connections
U1 FPGA Pin Schematic Net Name
P2 SFP Module Connector
Pin Number Pin Name
D13 SFP_RX_P 13 RDP
C13 SFP_RX_N 12 RDN
B14 SFP_TX_P 18 TDP
A14 SFP_TX_N 19 TDN
T17 SFP_LOS 8 LOS
Y8 SFP_TX_DISABLE_FPGA 3 TX_DISABLE
A12 SFPCLK_QO_N
(1)
U47.6
(2)
-
B12 SFPCLK_QO_P
(1)
U47.7
(2)
-
Notes:
1. The 125MHz SFP clock is sourced by clock driver U47.
2. Not P2 SFP module pins.